Italkero Eco SC Series, Установка и послепродажное обслуживание

Страница: 15 / 40

15 INSTALLER
general information
The appliance is sealed off from the room; its combustion
air is drawn from outside.
- DO NOT use non-original accessories or parts for the
installation; doing so is hazardous.
- DO NOT route the power cable over hot surfaces such
as the air outlet grilles or flue pipes.
once the appliance has been installed, the installer must
inform the user on how to use it:
- DO NOT place curtains, towels or other such objects
on the appliance; doing so can cause it to malfunction
and compromise the circulation of air in the room.
- DO NOT obstruct the appliance's intake/discharge
terminal with laundry or carpets.
Positioning tHe aPPliance
Before you install the appliance, make sure there is
sufficient clearance for it to operate properly and for
maintenance.
Make sure that the wall to which you are going to mount
it is able to support its weight; check that the included
plugs can bear the appliance's weight in relation to
the material of the wall; if not, use more appropriate
equipment.
Check for wooden, plastic and other non-heat resistant
mouldings which may come into contact with the flue
pipes.
The material of the wall must be able to handle the heat
of the flue pipes (around 180°C)
If the wall is not sufficiently heat resistant, you must
provide an air gap around the flue pipe and insulate it
with heat resistant material, or make a hole at least 4 cm
larger than the flue pipe.
Do not install the heater inside the clearances for
bathrooms or showers, or close to water delivery
equipment.
Such installations require special protective equipment
to make the appliance conforming with the applicable
electrical safety regulations.
installation
sV