DAP and DAPE configuration
The Infineon DAP/DAPE Active Probe supports DAP interface operation or simultaneous DAP
and DAPE interface operation at maximum DAP/DAPE frequency.
Operational modes
·
DAP Standard, a 2-pin DAP with single data line (default) or
·
DAP Wide, a 3-pin DAP with two data lines
Clock
- The DAP frequency must be configured with the frequency being entered in kHz.
DAPE
- Enable for simultaneous DAP and DAPE operation. The Debug channel mode should
be set appropriately from the drop-down list options and, as before, valid clock frequencies for
both interfaces should be entered in kHz. When the DAPE interface is not in use, ensure the
DAPE checkbox remains unchecked.
Содержание IC57163
