ISPA PORTABLE SPA 2009, Руководство пользователя

Страница: 7 / 48

Pr
eparing f
or
Your Ne
w P
or
tab
le Spa
5
Allow for Service Access
Many people choose to install a decorative structure
around their spa. If you are installing your spa with
any type of structure on the outside, such as a gazebo,
remember to allow access for service. It is always best
to design special installations so that the spa can still be
moved, or lifted off the ground.
Preparing a Good Foundation
Damage caused by inadequate or improper foun-
dation support is not covered by the warranty .
It is the responsibility of the spa owner to provide a
proper foundation for the spa.
We strongly recommended that you have a qualified, li -
censed contractor prepare the foundation for your spa.
Place the spa on a level concrete slab not less than 3”
/ 8 cm thick. If you are installing the spa indoors, pay
close attention to the flooring beneath it. Choose floor -
ing that will not be damaged or stained.
If you are installing your spa on an elevated wood
deck or other structure, consult a structural engineer
or a contractor to ensure the structure will support the
weight of 150 pounds per square foot.
120 Volt Electrical Installa-
tion
The iSpa can operate on either 120V or 240V power.
Although its default factory configuration is 240V, it can
be converted to 120V.
When configured as a 120V appliance, it is a cord-con -
nected spa with a pump heater, lighting fixture, and spa
side control. The operating power is 110V AC.
A licensed electrician may be required to upgrade your
standard receptacle and/or circuit breaker. Always fol-
low applicable local, state and federal codes and guide-
lines.
The spa is equipped with a 15 amp GFCI cord and plug
kit.
Plug the spa into a dedicated electrical line with a 15
amp breaker.
Always use a weatherproof-covered receptacle. Recep-
tacle shall be located not less than 5 feet (1.5 m) from
and not exceeding 10 feet (3.0 m) from the inside wall
of the spa (NEC 680.43(A)).