ISPA PORTABLE SPA 2009, Руководство пользователя

Страница: 16 / 48

2009 iSpa Owner’s Manual
LTR20091084, Rev. A
Operating
Your Spa
14
Electronic Control Operation
Initial Start up
When first powered up, your spa will perform a self-
diagnostic check and go into priming mode. The topside
will display
PR
to indicate this. Priming mode will be
active for less than five minutes.
Sometimes the pump fails to prime, especially when
spa owners do not fill their spas through the filter can -
ister. You can avoid priming problems by following these
steps during priming mode.
Press the JETS button to turn on the pump and let 1.
it run for 10 seconds. The pump should be running
in low speed.
Press the JETS buttons again and let the pump run
2.
in high speed for 10 seconds.
Press the JETS button again to turn off the pump.
3.
The pump should be left in the off position for 10
to 15 seconds.
Repeat steps 1 through 4 until water is flowing 4.
through all the jets and all air is removed from the
plumbing.
When the spa has finished priming, the heater will be
activated and the water temperature will be maintained
in standard mode. The spa will heat to 100°F (37.5°C)
at start up until the set temperature is changed as de-
scribed below.
Temperature Adjustment
(Range 80°F to 104°F, 26°C to 40°C)
The electronic control panel displays the actual water
temperature in degrees Fahrenheit. The displayed tem -
perature will only be current after the pump has been
running for at least two minutes.
To display the temperature that the spa is set to:
Press either the •
Up
or
Down
button. The tempera-
ture setting will flash.
While the display is flashing, each time you press
•
the
Up
or
Down
button, the set temperature will
change up or down one degree.
Jets Light Cool Warm Warm