13
From the locked condition with the red security
lock light on, it is possible to reactivate the system
by pressing the illuminated reset button for a few
seconds.
Caution !!
Before starting each sanitation cycle in the
“Cleaning surface” mode, it is mandatory to make
sure that there are no people or other living beings
in the environment to be treated as poten-
tially harmful UVC radiation is used.
The presence detection system could determi-
ne the block even outside the sanitation cycles
in the “Cleaning Surface” mode. It will therefore be necessary to press the reset command before giving
the start.
The timer emits a 10-second sound at the end of the work session, only when the cycle is carried out correctly for
the entire set time.
COMMANDS
A control console is provided for the operation of the system, to be installed outside the environment to be sani-
tized. (For dimensional indications refer to the paragraph on technical characteristics).
The components present on the console are:
•
A control console is provided for the operation of the system, to be installed outside the environment to be
sanitized. (For dimensional indications refer to the paragraph on technical characteristics).
•
The components present on the console are:
•
A reset button for reactivating the system following the detection of movement in the environment where the
Twist products are installed.
•
Un switch on the right side for selecting the “Cleaning Air” or “Cleaning Surface” operating mode correspon-
ding to the switch pressed.
•
on the right side of the console there are also two indicator rectangles that indicate:
•
green square lit> sanitation cycle is in progress
•
red box illuminated and timer off> system locked for safety to detect the presence of movement in the envi-
ronment to be sanitized.
