
1. iSmarGate-01W Instructions for use
iSmartGate-01W
www.
v2fe
.com
1.1 Quick Starter
-Wire up iSmartGate01W to our garage control panel.
See section 2.
-Configure the network requirements on the iSmartgate-01W.
See section 3.
-Configure the iSmartgate-01W according to the desired mode.
See section 4
1. The desired name for the door. The default name is "home", but you can change it for anyone you want.
Just take into account that it has to be no more than 8 characters, in lowercase.
2. The desired password. The default password is "12345678". You can change it, just take into account that
it has to be 8 numeric characters.
3. The IP Broadcast of our network. The default one is "192.168.1.255"
4. The network port. The default one is 8001.
5. The mode you want the device to work, The default setting is "Garage"
Lastly, open the iSmargate app on your smartphone, and follow MY GATES >
ADD GATE
. You will be asked for
the follwing data, just be sure to complete all these fields with the same data entered in the iSmartgate Device:
1. Gate Name
2. Port
3. Password
4. Mode
INSTALLATION MANUAL · iSmartGate 01W ·
English / REV.3
3
NOTE
The iSmartgate-01W IS NOT AN AccessPoint (AP). It works as a CLIENT device (AP Client).
Therefore, it requires an AP network device (AP Wi-FI, Router Wi-Fi).
The
iSmartgate-01W
works as a plug-in for any garage door. It comes with 2 relay outputs that can be controlled with
any iOS / Android smartphone.
These 2 outputs need to be connected to the existing garage door's control panel.
In order to allow the
iSmartgate-01W
get connected to the smartphone, you will need either an
Access Point Wi-fi (AP)
or a router Wi-fi. The
iSmartgate-01W
will connect through Wi-fi to the router/AP, and so will do the smartphone, once
it has the iSmartgate App installed. This, our smartphone and the iSmartgate device will be able to get connected
eachother.
Before proceeding with the installation, please read safety instrucions in section 1.2
In order to allow the iSmartgate App get connected to iSmartgate-01W, you need to complete the following steps:
Next, you need to put the next data, using the buttons and the display on the device:
It's Not necessary to put here the IP broadcast