iSmarGate 01W, Инструкция по эксплуатации, Страница: 16 / 29

INSTALLATION MANUAL · iSmartGate 01W · English / REV.3
16
iSmartGate-01W
www.
v2fe
.com
If the AP or Wi-fi router has been successfully configurated, the
iSmargate-01W should be connected to it.
To verify it, you need to run the
dgdiscvr.exe
and, if this software is able to find the iSmartGate-01W,
the network configuration has been successfully completed
.
In any other case, go back to step 3.6.
3.5. Step 5: Verification
To avoid communication errors, you should set the parameters in WiFi
AP or Router , which will connect the equipment iSmartGate-01W, as follows:
(in general way)
Wifi Settings -> ADVANCE -> 54G MODE -> 802.11b Only
ATTENTION
Reference example:
Once you have configured the
iSmartGate-01W
with the SSID and the safety options,
you need to
configure the AP or Wi-fi router with same data.
Please check that:
Once you have finished configurating your AP or wi-fi Router, switch off, and the switch on again
your iSmartgate-01W.
Wait until the yellow LED on your iSmartgate stays illuminated (not flashing) to move on to the next step.
If this doesn't happen, go back to step 3.6.
· The PC where the dgdiscvr.exe is running, is correctly connected to the
Ap or Wi-fi router through an ethernet connection.
· The iSmartGate-01W is close to the AP or router , in order to avoid coverage problems.
3.4 Step 4: AP / Wi-Fi router Configuration