INSTALLATION MANUAL · iSmartGate 01W ·
English / REV.3
20
iSmartGate-01W
www.
v2fe
.com
4.4. Function Mode Configuration
This is a very important parameter as it will decide the way the iSmartgate-01W works.
As with the previous configurations, the selected mode will be the same running on your iSmartgate App on your
smartphone. The default mode for this parameter is “
Garage”.
If you want to change it, just follow these steps:
1.
Press the button #1 until it shows the following message: "
3-TYPE
"
2.
Press OK (button #3)
3.
The display message will ask you if you are sure you want to change the function mode. Press OK.
4.
As you press the button #1, you will be able to navigate through all the existing modes.
5.
As soon as you see on the display the desired Function mode, press the OK button (button #3).
4.5. Port Configuration
This is the network parameter which defines the port in which the communication will be realized. You don't
need to modify it, unless you have more than one iSmartgate device in the same LAN/WLAN network. If this is the
case, you will need to select a different port for each of them, bearing in mind that them have to be comprended
between port 8000 and 65535.
The default port configuration is “
8001”.
If you want to change it, just follow these steps:
1.
Press the button #1 until it shows the following message: "
3-PORT
"
2.
Press OK (button #3)
3.
The display message will ask you if you are sure you want to change the door's network port.
Press OK (button #3).
4.
As you press OK, the current enabled network port will show up on the display. The numeric character which
is flashing is the one you are about to change, to do that press button #2.
Once it is correct, you can move
on to the next character pressing the SEL button (button #1).
5.
Once you have the desired port selected, press OK (button #3).
