iSHAN YGL-G, Руководство по эксплуатации

Страница: 14 / 27

14 - 27
1 Scope of application
iSHAN centralized lubrication systems are designed to lubricate ball bearings, flat
bearings, flat slideways, circular slideways, linear guides, cams, gears, chains, etc..
iSHAN centralized lubrication systems are suitable for the lubrication of various
machines, such as lathes, mills, presses, planner, grinder, etc. It is fit to control different
lubricating points at the same time against different machines.
YGL-G reservoir capacity: Available with 800ml
、
1200 ml
、
2000 ml
。
YGL-G120/G200 w/spring loaded follower plate: Permitted grease grade No.0/00/000/1
。
YGL-G080/G120/G200: Permitted grease grade No.00/000
。
YGL-G control type: timer control and PLC control
。
Only new lubricant shall be used.
YGL-GA is designed for intermittent lubricating. The interval can be set up from 1 to 999
(unit
：
second/minute/hour/count)
；
The lubrication time can be set up from 1 to 999 (unit
：
second/minute). iSHAN default setting of time unit for interval is minute and for lubrication is
second. The operator can adjust intermittence and lubrication time depends on the application.
YGL-G max. output volume is up to 16ml/min. The lubrication unit contains a pressure
relief valve in order to prevent injury, death, or property damage. The pressure relief sets on
100 kgf/cm
2
。
*Before installing, read the manual for the correct connection of the power. To prevent
chance of serious injury, death or property damage, disconnect the product from main
power supply before working on it.
*Comply with the specifications on the rating plate of the motor or the electrical
components..
*iSHAN products must only be used for their intended purpose. The described product is
for supplying centralized lubrication systems with lubricant and is intended for use in
centralized lubrication systems. Any other use of this product constitutes improper use.
2-1.2 Before lubricant filling
* You must observe the machinery manufacturer's information on the lubricantsto be used
in the machinery.
* Use only new oil with a permitted range of grease grade No. 00/000.(Model with
spring-loaded follower plate can use No. 0
，
1 grease)