isel
Gantry and Flat-Bed Machines
Page 3
3
Safety Notes
-
Do not run the machine in an atmosphere subject to the hazard of explosion!
-
The machine is enclosed on all sides. The enclosure protects you from moving tools, reduces
the noise level and retains the swarf. The cover is locked and cannot be opened during
machining. This safety device must neither be removed, nor be modified.
-
Always ensure that the workpieces are mounted securely.
-
The CNC operator panel possesses an EMERGENCY STOP switch for emergency cases,
interrupting the power supply to the power electronics (motor output stages) and to the
frequency converter for the main spindle drive. The shutdown is performed according to Stop
category 1 (controlled shutdown and subsequent interruption of the power supply to the
drives).
-
Only qualified and instructed persons are allowed to use the keyswitch on the CNC operator
panel, since the test mode involves an increased injury hazard.
-
The spare key must be kept under lock and key.
-
Provide for sufficient ventilation in case of dust or gas formation
from
the machining of the
materials.
-
Do not use running water for cooling, but only a cooling system (see "Accessories") which
produces its cooling effect with water mist or air. Make sure that no drips are formed and able
to flow under the clamping plate.
