isel automation EuroMod F, Инструкция по эксплуатации, Страница: 18 / 30

isel Gantry and Flat-Bed Machines
Page 14
...Front side operator panel, cont'd
6 Stop button
... immediately halts the program currently running immediately and stops at the
current (program) point. The machine tool remains turned on, and the cover (if
installed) remains locked.
7 Cover button
... deactivates the safety lock when actuated, thus allowing the cover to be opened
provided that all relevant requirements for the SC module are fulfilled. This button is
only operative when the button is lit.
8 Ack button
To traverse the axes in the TEST mode, the "Acknowledgement" button (enable
button)
... must be held down in the TEST mode when the cover is open. If you release the
button with the cover open, the SC module will turn off the drive control (power
section).
9 Keyswitch
Use the keyswitch to switch between the AUTO and TEST modes.
AUTO = machining mode (it is possible to turn on the machining spindle)
TEST = test mode (it is not possible to turn on the machining spindle)
In the TEST mode, you can open the cover at any time.
Switching AUTO ▬▬► TEST while machining a workpiece decelerates the
machining spindle. After switching back to the AUTO mode, the machining
spindle restarts. This may cause damage to the machining spindle or to the
workpiece if the mode change is not performed while the axes of motion are
stopped.
10 USB ports
The USB port is the interface via which the data exchange between user and
PC takes place. You can use the USB ports to transfer programs or drawings created
on another computer to be able to machine a workpiece. To be able to execute the user
program ProNC, the enable dongle (Wibu) must be connected to a USB hub.
6.3.2 Side operator controls
After you have turned on the main switch on the control
cubicle, you can start the PC. To this end, actuate the
button which is located on the side of the operator
panel.
The operator controls for the monitor are situated above
the button. Here you can make colour and contrast
settings using a sharp-pointed object (ball-point pen or
the like).