Iseki TH4295, Руководство по эксплуатации

Страница: 61 / 113

TH4295,4335,4365
58
Rear Linkage
FIG. 5-33: Linkage consists of several major compo-
nents for implement attachment and operation:
Lower Links, 1 - Primary attaching points to lower
implement pins.
Lift Rods, 2 - Connect lower links to hydraulic lift
arms for raising/lowering of lower links. The lift rod
connected to the right lower link has provisions for
leveling the implement (side to side).
Check Chain, 3 - Reduce side away of implement.
Top Link, 4 - Adjustable, turn-buckle type to level
implement (front to rear). Top link also provides draft
load sensing for draft control.
FIG. 5-34: To match varying implements, rear link-
age is standardized according to spacing, pin size,
etc. This enables usage of alternate implements with
minimal adjustments as long as matching size or “Cat-
egory” is used.
This Tractor is equipped for “Category I ” implements
with following attaching point dimensions:
Ref. Description Dimension (Size)
A Lower Link Width 26.8” (681 mm)
B
Lower Link Pin
Diameter
0.88” (22 mm)
C Top Link Height 18” (457 mm)
D Top Link Pin Diameter 0.75” (19 mm)
FIG. 5-35: The linkage provides two positions of con-
necting the top link, 1, to the tractor.
For most implements, securing the top link, A, is
satisfactory, but the position may be varied to provide
increased implement height during transport.
FIG. 5-36: Lift rods, 1, and lower links, 2, also have
multiple positions. Normally, Center hole, A, in each lift
rod is attached to forward hole, X, in lower link.
CAUTION: Secure all pins after adjust-
ment is made. Always use pins supplied
with Tractor.
FIG. 5-33
FIG. 5-34
FIG. 5-35
FIG. 5-36
1
2
4
3
2
X
B
1
A