Iseki TH4295, Руководство по эксплуатации

Страница: 63 / 113

TH4295,4335,4365
60
Using Position Control
FIG. 5-40: Type of Work - Attaching/detaching imple-
ments and other operations requiring implement to be
kept at constant height above ground. Also used with
tool bars having flexible row units and implements
equipped with gauge (support) wheels.
FIG. 5-41: Lever Positions - Use position control lever,
1, to adjust hitch and implement position.
NOTE: Front lever stop, 2, can be set to contact
position control lever in implement work posi-
tion. This enables implement to be returned
to identical position after hitch has been
raised for turning, transporting, etc. Rear le-
ver stop, 3, can be set to limit raising height,
if required.
To Begin Work - Align Tractor and implement in field
and move position control lever, 1, forward (toward
DOWN). Adjust implement height using position
control lever and set adjustable stops, 2 and 3, as
desired.
When Turning - Move position lever, 1, backward (to-
ward UP) to raise implement. Finish turning and return
lever against stop to resume operation.
To Finish Work and Transport - Move position control
lever, 1, fully rearward in quadrant.
FIG. 5-42: Lowering speed can be readjusted as nec-
essary using lowering rate control knob, 4.
CAUTION: When using mounted imple-
ments with PTO driveline, make sure:
PTO drive shaft has minimum 51 mm
(2”engagement of telescoping sections,
at all hitch/implement positions.
Hitch height during raising does not bind
drive shaft universal joints due to extreme
drive shaft angles. Limiting raising height
may be required.
PTO drive is disengaged during transport.
2
1
3
4
FIG. 5-40
FIG. 5-41
FIG. 5-42