OPERATION
59
Attaching Implements
CAUTION: Always use POSITION CON-
TROL to attach/detach implements to
provide precise control of hitch.
FIG. 5-37:
Back Tractor to implement, centering Trac-
tor with implement hitch frame.
Raise or lower hitch using position control lever, 1,
and align left lower link end with corresponding imple-
ment attaching pin.
Lock the brakes, shut off engine and remove key.
FIG. 5-38:
Slide ball end of left lower link, 1, over
implement pin and secure with linchpin.
Adjust height of right lower link using leveling turn
buckle, 2. Attach and secure right lower link, 3, to
implement with linchpin.
Attach top link, 4, to top of implement hitch frame
using pin supplied with Tractor. Rotate center barrel
section of top link, to lengthen or shorten it, and level
implement from front to rear.
After the implement is attached, it can be readjusted
for level operation using turn buckle and top link. Se-
cure all adjustments.
IMPORTANT: With some mounted implements, it
will be necessary to remove drawbar
at rear of Tractor to permit implement
to be raised and lowered without ob-
struction.
FIG. 5-39:
Certain implements require minimal side-
play. Check chain, 1, at each lower link should be
evenly adjusted to reduce side-play to desirable level.
Do not remove all side-play as lower link damage may
result.
NOTE: The amount of side-play (stabilizer loose-
ness) is dependent upon implement and type
of operation. Normally 2” (50mm) of total side
movement is desired, 1” (25mm) to each side
of Tractor centerline.
FIG. 5-37
FIG. 5-39
FIG. 5-38
1
3
2
4
1
1
Содержание TH4295
Страница 1: ...TH4295 TH4335 TH4365 MODELS I S E K I T R A C T O R S ...
Страница 3: ......
