INSTALLATION GUIDE
|
24
IM-Raptor-1.3.6-EN
7. Device Management
7.1 Serial Console
Connect a PC or terminal directly to the serial console to access the boot-time control and Raptor’s interfaces. The serial
console port provides access to the console interface.
The serial console port is RS232 with RJ45 connector with a console cable and port setup of 115200 bps, 8, N.
The serial console is intended to be used only as a temporary connection during initial configuration or
troubleshooting.
7.2 Ethernet Ports & Communication Cabling
The Raptor
comes with standard Ethernet ports. According to the link type, the switch uses CAT 3, 4, 5, and 5e UTP cables
to connect to any other network devices (computers, servers, switches, routers, or hubs).
For cable specifications, refer to the following table.
CABLE
TYPE
MAXIMUM LENGTH
DESCRIPTION
10BASE-T
Cat. 3, 4, 5 100
Ω
UTP 100 m (328 ft)
RJ-45
100BASE-TX
Cat. 5 100
Ω
UTP
UTP 100 m (328 ft)
RJ-45
1000BASE-T
Cat. 5/Cat. 5e 100
Ω
UTP
UTP 100 m (328 ft)
RJ-45
7.3 RJ45 Ethernet Pinouts
With 10/100/1000BASE-T(X) cables, pins 1 and 2 are used for transmitting data, and pins 3 and 6 for receiving data.
10/100 Base-T(X) RJ-45 pin assignments are as follows:
PIN NUMBER
ASSIGNMENT
1
TD+
2
TD-
3
RD+
4
Not used
5
Not used
6
RD-
7
Not used
8
Not used
