INSTALLATION GUIDE
|
14
IM-Raptor-1.3.6-EN
To install a power supply, perform the following:
Step 1: Insert the power supply modules in Power 1 and Power 2 slots respectively.
Step 1: Push and tighten every thumb screw until each power supply module is locked in position.
Step 1: Turn on power to the device and confirm that the PS module is receiving and supplying power. This is indicated by
PS1 and PS2 LEDs. If a LED's light is green, the PS module is receiving and supplying power.
5.2
Removal of Power Supply Modules from Chassis
Danger of electrocution hazard exists.
To remove a line module, perform the following steps:
Step 1: [Optional] If the device is installed in a rack, remove it from the rack.
Step 2: Loosen the screws securing the line module.
Step 3: Pull the module from its slot in the chassis.
Step 4. Install a new module or a blank module (to prevent accumulation of dust)
