iDS6
Series User’s Manual
iS5 Communications Inc.
34
LED will be on.
Eth1 link down
When Eth1 link goes down, a notification will be sent and Fault LED
will be on.
Eth2 link down
When Eth2 link goes down, a notification will be sent and Fault LED
will be on.
Apply
Click “Apply” to activate the configurations.
Note
: When Fault LED/Relay checkbox is marked and Fault Alarm is happened the
Contact Closure that is located on the terminal block (section 3.6) the pin 8 is shorted to
the pin 9. When no Fault Alarm is happened the pin 8 and pin 9 are opened.
Save/Reboot
5.1.5
The Save/Reboot allows the user to backup or restore a configuration. As well as return
to the factory settings, upgrade the Firmware or Reboot the server.
Save/Reboot interface
The following table describes the Save/Reboot interface page.
Label
Description
Factory Default
Click the “Reset” button to restore the Device server to the factory
defaults.
Restore
Restore a saved configuration by selecting the file through the
browse button and clicking “Restore”.
