FG5000/FG10000 Flywheel Grinder
Copyright © 2018, by Irontite Products Inc.
28
800-553-5953
All Rights Reserved Rev. 181102
ASSEMBLY DRAWING
Note:
Replacement Table Spindle must be
ordered using this part number.
794-8651-66
* Includes the press-fit bearings.
ITEM
PART #
DESCRIPTION
QTY
107
794-8017-44
E-Z Lock Insert
1
108
794-8016-07
SHCS 3/8-16 x 1.75
4
109
800-8012-92
O-Ring
4
110
794-8016-54
Oil Fill Plug
1
111
794-8013-12
O-Ring
1
112
794-8012-85
Table
1
113
000-2301-38
O-Ring
1
114
794-8651-04
Table Spindle
(see note above)
1
■
115
794-8651-06
Key
4
116
794-8012-95
Bearing
2
■
117
794-8012-76
Clamp
1
118
794-8012-82
Seal
1
To avoid damage to your Table Spindle (114)
it is recommended that you remove the E-Z
Lock Insert once a month and coat it with Anti-
Seize lubricant. This prevents the insert from
becoming permanently lodged in place from
rust and grit.
Should the Table Spindle Threads become
clogged with debris and you wish to clean them
you can use a 5/8-11 tap to clean the treads.
It is not recommended to continue using a
Table Spindle that has damaged threads. It is
preferable to replace the Table Spindle over
using a threaded insert as a repair.
TIP:
Stuck E-Z Lock Insert Removal
E-Z Lock Inserts that become stuck in place
can often be removed more easily if the Table
Spindle they are in is heated. The heat
loosens the insert enough to be able to coax
them out. Be very careful when applying heat
because of the lubricants used in and around
this area. Clean all oil and other potentially
flammable materials away from the area prior
to applying any heat.
