18
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
NOTE:
If applicable, install the firebox liner before placing the stone.
Logs can be installed after the volcanic stone.
Installing the volcanic stone, and glowing embers:
1.
If necessary, remove the glass door (Page 26).
2.
Spread the decorative volcanic stone in a pleasing pattern on the
firebox floor to the front and sides of the burner (Figure 10).
NOTE: Do not place volcanic stone on the burner.
3.
Separate and fluff the glowing embers into pieces approximately the
size of a quarter (Figure 11).
4.
Position the separated glowing embers over the small holes on the
burner surface (Figure 12).
Do NOT cover the large burner slots
.
NOTE:
Enough glowing ember material is provided for several applica-
tions. For best glowing effect, replace the ember material annually.
Figure 10 - Installing the volcanic stone (BV32 Shown)
Figure 11 - Separating the glowing embers
Figure 12 - Installing the glowing embers (BV32 Shown)
Log Number
Description
1
Rear Log
2
Left Front Log
3
Right Front Log
4
Left Cross Log
5
Right Cross Log
NOTE: It is important to ensure proper log placement per the manual when
installing these units. Verify pilot flame is not obstructed. See Verifying Appliance
Operation on Page 25.
2
4
3
1
5
Volcanic Stone
Figure 13 - Log Set