Quick Start Guide
The following are instructions on how to simply and quickly program an IQ-500
gate operator after it has been mounted to concrete pad and attached to the
gate.
Be sure to disconnect any magnetic or other gate locks before learning an
operator
.
1. With the power and battery disconnected, attach the IQ-500 wires to the
“Motor Control” board according to the direction that the gate opens:
The following example is for Left Hand operation
•
The RED wire inserted in the MOTOR B terminal
•
The BLACK wire inserted in the MOTOR A terminal
•
The WHITE wire tightened into a GND terminal on the motor board
•
The BLUE wire tightened into the ENCDR / A.C.L. terminal
•
Open and Closed limit switch wires are terminated accordingly with
there commons inserted in the GND terminals of the motor board
•
The bottom limit cam will be activating the open limit switch
2. Reconnect the power and / or batteries and turn on the On/Off switch on
the side of the control box
3. Set the appropriate date and time
4. After verifying that the path of the gate is clear, press the radio button on
the IQ Display board. At this time, the gate will begin to open.
5. When the gate reaches a desired open position, immediately turn off the
power switch on the side of the control box
6. Adjust the cam to activate the open limit at that point
7. Turn the On/Off switch back on
8. Scroll to the “Motor Drive Menu” and select “Number of Operators” = 1,
and then select “IQ Gate” as the Operator “IQ”. Scroll all the way
clockwise and “Exit the sub-menu”
9. Scroll to “IQ Gate Learning” and press the programming knob.
10. Scroll to and select “Enter for Motor 1”
11. The display will read “Use ‘Radio’ to learn Close Count”, press the
programming knob and the programming
*
will be displayed at the right.
At this point, press the RADIO button on the display board. If the gate is
not opened, it will begin to. Once the gate is fully opened, it will stop, a
series of relays will click, and then the gate will start to close. The gate
speed might slow down at some point during closing. This is normal and
will assist in accurate placement of the gate in the closed position. When
the gate reaches your desired closed position, press the RADIO button
again. At this point the gate will stop and reopen. When the gate is fully
opened and the relays quit activating, press the RADIO button once more.
When the RADIO button is pressed this final time, the programming
*
will
disappear and the gate will close to your selected position and stop.
23
