IPM IP-02S, Руководство по эксплуатации, Страница: 14 / 33

14
3. Place the conical spring (2) into the groove in the Air Cylinder Cap (10) followed by Gasket
(6). Clamp the Air Motor Base in to a vice and use a strap wrench to assemble the Air
Cylinder (3) and the Air Cylinder Cap to the Air Motor Base. Hand-tighten the Air Cylinder
cap.
4. Place the Connecting Ring (9) around the Connecting Rod Housing (8) and hand-tighten.
4.3 Disassembly Lower Fluid Section
1. Remove the foot valve while holding the cylinder with a strap wrench.
2. With the upper air motor assembly already removed, you should be able to simply push
from the upper ball end, the complete assembly out the bottom of the lower section.
3. Use two wrenches and dismantle the upper pump section. Note the orientation of the
Teflon cups. One goes up, followed by a wear ring in the center, and one goes down
followed by a lower support washer. Use Loctite-222 when re-installing.
Upper portion of the Lower Connecting Rod assembly.
Spring must be pushed
under the lip inside the cap