Section III
Operation
Page 3.24
BP
II S, 3.00
08/96
2. Press
to obtain this screen. The
X.XX represents the latest software
release number.
3. Pressing the
key will obtain this
screen. Press UP to execute the
LED/lamp test. The LED will light and a
test pattern will be displayed for 3
seconds in the display area.
NOTE: This test can be performed only from the front panel display.
4. Press
to obtain this message. This is
the beginning of a procedure to change
the language on the monitor panel if
desired. To leave it in English, press
.
This will skip to Step 7, below.
5. Pressing
in the step above will bring
out this screen. If you wish to change the
language it is necessary to confirm by
pressing
again.
CAUTION
If you don’t understand German, don’t perform this
step. You may get lost trying to get back into English.
6. Pressing
the second time changed the
language and obtained this
message(example shown in German).
7. Press
to obtain this message in the
language displayed in Step 6. The
message screens will now all be in that
language. Press
to confirm that this is
the desired language. Press
to change
the language. Refer to the manual
written in the appropriate language for
screen messages and instructions.
8. Press
to obtain this screen. This is the
start of the procedure if it is necessary to
change the date setting.
Software Rev. Level
X.XX 60 Hz
LED/Lamp Test
UP = Test
Language
English
Confirm
Yes=UP No=DN
Sprache
Deutsch
Confirm
Yes=UP No=DN
Date
mm/dd/yy
