IPG YLS-1000-K, Перевод оригинального руководства по эксплуатации

Страница: 65 / 171

65 YLS-K
For more information about the safety interface, see the supplied tech-
nical data.
External control and ramp function
It is not possible to use ramping times together with
the external control.
To operate the laser via the external control, do as follows:
1. Establish a connection to LaserNet, if this has not already been
done (see
TEST mode [
}
62]
).
2. Connect the external control to the safety interface (for the pin as-
signment of the safety interface, see the supplied technical data).
Laser emission via external control
If the button Emission ON is active, laser emission
can result upon connection of an external direct cur-
rent to the external control.
ð Do not switch on the control voltage of the ex-
ternal control.
Activating the ex-
ternal control 3. Open the
Control tab [ } 97]
.
4. Click on the button External control OFF (8).
The button then changes its status to ON. The external control is activated.
5. Click on the button Laser OFF (5).
The button then changes its status to ON. The laser power supply switches on.
6. Set the laser power (
TEST mode [
}
62]
).
7. Click on the button Emission OFF (6).
8. Set the signal Emission ON of the external control to HIGH.
The laser radiation is enabled. The laser emits the preselected laser power. You
can change the power at any time using the slider (2) or directly entering a new
value.
Deactivating the
external control
9. Set the signal Emission ON of the external control to LOW.
10. Click on the button Emission ON (6).
The laser emission stops.
11. Click on the button Laser ON (5).
The laser power supply switches off.
​ | Operation