emu3/emu3ACO Operation Guide 17
Version 2.1
Device Details: Configuring and controlling devices
Device Details: Configuring and controlling devices
While you can perform some actions from the Overview page in the IPE Dashboard, you will need to display a
specific Device Details page to configure any settings, such as the power-up sequence or IP addressing.
Note:
This functionality is only availabe to accounts assigned the
Administrator
role (see “Authentication: Managing
users” on page 20).
For details on toggling between the Overview page and a specific Device Details page, see page 14.
Each Device Details page contains the following collapsible panels:
•
Unit Information
: You can enter the following details for a unit:
–
Name (in the panel’s title bar)
–
Location: Textual description of the physical location of the unit
–
Notes: Any other relevant information
•
Unit Status
: This mirrors the status and control information shown on the unit’s tab in the Overview page. See
“Overview page: Status and control” on page 16.
•
Power Up Sequence
: Allows you to specify the order in which equipment attached to this unit is powered up.
See “Setting the power up sequence” on page 18.
•
Power Shedding
: see “Setting up power shedding” on page 19
•
Network Settings (Master unit only)
: Use this panel to change the IP addressing used by the Master unit and
any connected Slave units
•
Telnet Settings
: Use this to configure Telnet access; see “Telnet commands” on page 27
•
Authentication (Master unit only)
: see “Authentication: Managing users” on page 20
•
SNMP (Master unit only)
: Use this panel to enable or disable SNMP on this unit. emu3 units use SNMP v2c
protocol. The MIB (supplied by IPE Ltd) details all the available traps.
•
Web Server (Master unit only)
: Configures the web server on this unit (which controls whether the IPE
Dashboard information is made available). Allows you to choose between the HTTP and HTTPS protocols.
