IOT-WORKSHOP
DTU-H10X
Wi-Fi/Ethernet to RS485/RS232 Server User Manual
http://www.iotworkshop.com
19
reset to enable/disable Ethernet. Device need different configuration to support different Ethernet
Networking mode (Such as
“N-Ver" and “Z-Ver" as following, which need AT+FVER=n to switch
to N-Ver or AT+FVER=z to switch to Z-Ver).
2.2.1.
Ethernet Interface Networking (As AP, N-Ver)
Phone
Laptop
Tablet
W
i-F
i L
in
k
W
i-
F
i
L
in
k
W
i-F
i L
in
k
RJ45 Ethernet
DTU Device AP Mode
Laptop
AP
IP:10.10.100.254
IP:10.10.100.100
IP:10.10.100.101
IP:10.10.100.102
IP:10.10.100.2
Figure 11.
Ethernet Interface Networking (As AP)
For above networking, device
works as AP and also the centre of this network. All devices‟ IP
address in this network shall use the same network segment with device and they can
intercommunication with this method.
2.2.2.
Ethernet Interface Networking (As STA, N-Ver)
Laptop
Wireless
RJ45 Ethernet
Ethernet IP:10.10.100.254
STA IP:192.168.1.100
IP:10.10.100.100
Laptop
IP:192.168.1.1
Wireless
IP:192.168.1.102
Figure 12.
Ethernet Interface Networking (As STA, N-Ver)
For above networking, device works as STA
（
Firmware is N-Version
）
,and device configured as
router mode. When device connect to AP, it will get wireless port IP address from AP
（
For
example: 192.168.1.100
）
.At the same time, device also form a subnet
（
Default 10.10.100.254
）
and all devices connected to device Ethernet interface will get assigned IP address
（
For example:
