MH860 series hydraulic servo drive
Operating through the LED panel
48
parameter ID. If you press and hold the
SET
key and then release it, the LED displays the
parameter value. If you press the
or
key, the changeable places blink. If you
want to modify a parameter, you can press the
key to move the blinking place and press
the
or
key to change the value of the blinking place. After the value is modified,
press and hold the
SET
key and release it. Then the modification is automatically saved and
blinking stops. If you press the
or
key again at this time, you can modify the
parameter again. The places which can be modified blink. Press the
MODE
key to exit.
Note:
The drive, motor, and oil pump selection is different from other parameter selection.
Parameter setting flowchart:
MODE
SET
MODE
SET
MODE
B
lin
k
in
g
B
lin
k
in
g
For calibration commands, such as pressure linear zero calibration, after the setting: if
the LED displays 0, the calibration succeeds; if the LED always displays 1, the calibration
failed.
Drive setup flowchart:
MODE
SET
MODE
MODE
3 not blinking
Select model
3 blinking
Any key
Scroll to display model
SET
SET
SET
Press and hold to
save
Motor setup flowchart:
