Invivo Millennia 3155A, Руководство по обслуживанию

Страница: 44 / 76

5-2
NOTE
The HE61 RF antenna should be disconnected from the HE60 or AB182B transceiver
while performing the radio programming procedures in this section.
NOTE
*If the radio transceiver was originally programmed as a base unit, “:Base” will be
displayed in the above step. Similarly, “:Remote” will appear if the transceiver was
preprogrammed at the factory as a remote unit.
NOTE
The HE61 RF antenna should be disconnected from the HE60 or AB182B transceiver
while performing the radio programming procedures in this section.
c. Plug the 13-pin side of the test fixture’s DB25 cable into the mating jack on the HE60
or AB182B transceiver.
d. Attach a fully charged 9 Vdc battery to the separately supplied pigtailed battery cable (red
and black wires), but do
not plug the other end of the battery cable into the mating
transceiver jack.
e. Initialize the Com24 application software.
f. Verify or select the following setup parameters:
!
BaudRate - 9600 bps if new radio (9600, 19200, or 57600 for reprogram).
!
ComPort - Set to match spare COM port attached to test fixture in step “a” above.
g. Plug the free end of the separate pigtailed battery cable into the mating jack on the HE60
or AB182B transceiver (with 9 Vdc battery attached).
h. Press any key to start.
i. The following message is displayed on the screen:
WIT2400 [or WIT2410] v[ x.y ] Digital Wireless (C) [ Date ]
:Base [or] :Remote*
i. Press the <F3> key.
j. A data entry prompt (“>”) is displayed on the screen to indicate the HE60 or AB182B
transceiver has entered the programming mode.
k. Proceed to paragraph 5.5, 5.6, or 5.7 depending on how it is desired to program the HE60
radio transceivers for your system.
5.4 Monitor Setup. Perform the following steps to prepare HE60 or AB182B radio transceivers
installed in the Millennia
®
3155MVS/3155A monitor for receiving programming instructions:
a. Remove top cover (Reference Section 3: Disassembly Procedures).
b. Attach the keyboard cable (and adapter cable if necessary) to the keyboard connector on
the AC266 (located at a 90
"
angle to the rear panel on the right side of the monitor
screen).