Invivo Millennia 3155A, Руководство по обслуживанию

Страница: 29 / 76

2-9
NOTE
Loss of communication, or no communication, between the
3150/3150M
and
Millennia
®
3155MVS/3155A
monitors is indicated by the 3150/3150M displaying "COMMAND
LINK: LOST" and "DATA LINK: UNKNOWN," and on the 3155MVS/3155A by a gap
appearing between the squares in the Remote box and the STATUS changing to red with
no waveforms being displayed.
e. Depress (press and release) the NIBP START/STOP Control Key on the Millennia
®
3155MVS/3155A monitor.
f. Verify that the NIBP pump on the 3150/3150M monitor starts up.
g. Depress (press and release) the NIBP START/STOP Control Key on the Millennia
®
3155MVS/3155A
monitor.
h. Verify that the NIBP pump on the 3150/3150M monitor shuts off.
2.7.1 Remote Parameter Verification. Verify Remote Parameter monitoring as follows:
a. Connect Patient Simulators to the 3150/3150M monitor.
b. Verify ECG Waveform and Rate are the same on both the 3150/3150M and Millennia
®
3155MVS/3155A monitors.
c. Verify P1 Waveform and Values are the same on both the
3150/3150M
and
Millennia
®
3155MVS/3155A
monitors.
d. Verify P2 Waveform and Values are the same on both the 3150/3150M and Millennia
®
3155MVS/3155A monitors.
e. With P2 still ON, verify that the SpO2 Value is shown with no waveform and is the same
on both the 3150/3150M and Millennia
®
3155MVS/3155A monitors.
f. Turn P2 OFF and verify SpO2 waveform is now displayed.
g. Verify EtCO2 Waveform and Values are the same on both the 3150/3150M and
Millennia
®
3155MVS/3155A
monitors.
2.8 Recorder Verification. (If the Recorder Option is installed) Verify proper operation of
the Recorder as follows:
a. Enter SYSTEM CONFIG through the SETUPS Menu and Enable the Recorder.
b. Set the Patient Simulator on the 3150/3150M monitor to output a 1mV square wave at
2 Hz.
c. Select a Sweep Speed of 25mm/s in the SETUPS Menu of the Millennia
®
3155MVS/3155A monitor.
d. Press the RECORD Control Key on the
Millennia
®
3155MVS/3155A
monitor.
e. Verify a LO speed printout that is a full cycle of 2.5 blocks.