Invivo Millennia 3155A, Руководство по обслуживанию

Страница: 43 / 76

5-1
NOTE
Contact IRI’s Technical Support staff at 1-888-221-1593 (M-F, 9am-5pm ET) to
acquire the latest programming command lines before attempting to reprogram the
radio(s).
SECTION 5
HE60 RADIO TRANSCEIVER
PROGRAMMING INSTRUCTIONS
5.0 PROGRAMMING INSTRUCTIONS
5.1 Introduction. The WIT2400 (Invivo P/N HE60) radio transceivers can be programmed and/or
reprogrammed to accommodate various communications setup configurations for the Millennia
®
3155MVS/3155A monitors , Model 3150/3150M monitors , and AS163 Siemens Transceiver
Modules. This section provides setup information and specific instructions to program the radio
transceivers for operation in the various system configurations.
The WIT2410 (Invivo P/N AB182B) radio transceivers are new radios required with dual 3155
communications setup configurations and on
3155MVS
or
3155A
monitors communicating with
3150 or 3150M communications setup configurations, but cannot be used in communications setup
configurations for the Millennia
®
3155MVS/3155A monitors, Model 3150/3150M monitors, and
AS163 Siemens Transceiver Modules .
5.2 Required Test Equipment. The following test equipment is required to program the HE60
or AB182B radio transceivers for use with the
Millennia
®
3155MVS/3155A
monitors:
Com24 Setup (See paragraph 5.3.)
!
TF0078 Test Fixture
!
Two 9 Vdc batteries
!
WIT2400 (Invivo P/N HE60) or WIT2410 (Invivo P/N AB182B) radio transceiver
!
IBM-compatible pc with Windows 9x/2000/XP installed
!
Cirronet Com24 (Version 2.2 for DOS) communications software application located on
“
3155 MVS/3155A Monitors, Technical Support CD
” (Invivo P/N 9546CD)
Or:
Monitor Setup (See paragraph 5.4.)
!
Millennia
®
3155MVS/3155A monitor with WIT2400 (Invivo P/N HE60) or WIT2410
(Invivo P/N AB182B) radio transceiver installed
!
IBM pc-compatible 101-key keyboard with standard connector (or Standard-to-PS2
keyboard cable adapter attached)
5.3 Com24 Setup. Perform the following steps to prepare HE60 or AB182B radio transceivers
not installed in the Millennia
®
3155MVS/3155A monitor for receiving programming instructions:
a. Plug the test fixture’s DB25 connector into an unused pc serial COM port (use a DB25-
pin to DB9-pin adapter if required).
b. Attach a fully charged 9 Vdc battery to the pigtailed battery cable (red and black wires)
located on the pc side of the test fixture’s DB25 cable.