INVENTOR ICI-12, Руководство пользователя

Страница: 55 / 63

No. Name
1 Wall Surface
2
Bottom Plate of Wire Controller
3 Screw M4X10
4
Panel of Wire Controller
2. The communication distance between the main board and the wire controller can be as far as
20m (The standard distance is 8m).
3. The wire controller shall not be installed in a place where there is water drop or large amount of
water vapor.
H. Connection of Signal Line of Wire Controller
1. Open the cover of the electric box of the indoor unit.
2. Pull the signal cable of the wire controller through the rubber ring.
3. Plug the signal line of the wire controller onto the 4-bit pin socket (J6) at the circuit board
of the indoor unit.
4. Use cable fastener to bundle and fix the signal cable of the wire controller.
I. Power Cable Connection
Caution:
Before installing the electrical equipment, please pay attention to the following
matters which have been specially pointed out by our designers:
（
1
）
Check that if the power supply used conforms to the rated power supply specified on the
nameplate.
（
2
）
The capacity of the power supply must be large enough.
（
3
）
The lines must be installed by professional personnel.
An electricity leakage protection switch and an air switch with gap between electrode heads
larger than 3 mm shall be installed in the fixed line.
1.Connection of single wire
（
1
）
Use wire stripper to strip the insulation layer (25mm long) from the end of the single wire.
（
2
）
Remove the screw at the terminal board of the air-conditioning unit.
（
3
）
User pliers to bend the end of the single wire so that a loop matching the screw size is
formed.
53