Excelerator XLT Series
54
Part No. 1114850
GLOVES (FIGURE 7)
1. Wrap palm loop around horizontal handle (
using top slot only
) and secure to
glove.
2. Run glove loop through bottom slot on palm and over back of hand until tight.
Secure glove loop to back of glove.
3. Reattach glove strips to back of glove.
Glove
Horizontal Handle
FIGURE 7 - GLOVES
Palm
Loop
Top Slot
Palm Loop Secured to Glove
Bottom Slot
Glove Loop
Glove Strip
Glove
Strip
HAND CRANK HANDLES (FIGURE 6)
HORIZONTAL HANDLES/
DELRIN HANDLES
1. Secure handle to hand crank with the
screw.
2. Remove the screw to remove handle from
handcrank.
VERTICAL HANDLES
1. Position handle onto crank as shown in
DETAIL "B" of FIGURE 6.
2. Tighten set screw to secure handle to
crank.
3. Reverse STEPS 1-2 to remove handle.
TRI-PIN QUAD HANDLES
1. Refer to VERTICAL HANDLES in this
procedure to remove/install tri-pin quad
handles.
2. Loosen socket screws to adjust handle
position, as shown in DETAIL "C" of
FIGURE 6.
3. Tighten socket screws to secure handles in
desired position.
V OR S CRANK HANDLES
Replacement/installation of V or S crank handles
should be done by a qualified technician.
Tri-Pin
Quad
Handles
Socket Screw
FIGURE 6 - HANDCRANK
HANDLES
DETAIL "C" - TRI-PIN QUAD
HANDLES
DETAIL "A" - HORIZONTAL
HANDLES/DELRIN HANDLES
DETAIL "B" - VERTICAL HANDLES
Horizontal
Handle
Hand Crank
Vertical Handle
Hand Crank
Set Screw
Screw
SECTION 8
OPTIONS
OPTIONS
All manuals and user guides at all-guides.com