Part No. 1114850
37
Excelerator XLT Series
REPLACING CAMBER
INSERTS (FIGURE 4)
1. Loosen, but do not remove the socket
screws and clamps that secure the
camber inserts to the camber bar.
2. Remove the existing camber insert
from the camber bar.
3. Install the new camber insert into the
camber bar.
4. Adjust the toe in/toe out of the
wheelchair. Refer to DETERMINING/
ADJUSTING TOE IN/TOE OUT in
this section of the manual.
Socket Screw
Clamp
Frame
Camber Bar
Camber Insert
FIGURE 4 - REPLACING CAMBER INSERTS
ADJUSTING TOE IN/TOE OUT
1. Loosen, but do not remove the socket
screws and clamps that secure camber
inserts to the camber bar (DETAIL "A"
of FIGURE 3).
2. Slowly rotate the camber insert until
the rear wheels are approximately in a
straight line.
3. Securely tighten the socket screws and
clamps that secure the camber inserts
to the camber bar.
4. Measure the distance between the
center lines at the rear and front of
the rear wheels at approximately 12-
inches from the ground/floor. Refer to
DETERMINING TOE IN/TOE OUT
in
this procedure of the manual.
5. Repeat STEPS 1-4 until the toe in/toe
out measurement is less than 1/8-inch
(for maximum rollability).
SECTION 6
WHEELS
WHEELS
FIGURE 3 - DETERMINING/
ADJUSTING TOE IN/TOE OUT
Camber
Insert
Camber Bar
Socket Screw
Clamp
Toe-in
Larger Than Front
Toe-out
Top View of
Wheelchair
FRONT OF WHEELCHAIR
DETAIL "A"
Smaller Than
Front
All manuals and user guides at all-guides.com