SECTION 9—WHEELS
Part No 1134343
53
Crossfire
™
T6A Wheelchair
5. Install
the
four
socket
screws
and
washers
into
the
desired
mounting
positions
of
both
camber
tube
clamps.
Hand
tighten.
NOTE:
Ensure
that
both
camber
tube
clamps
are
adjust
to
the
same
position
in
the
camber
tube
support.
This
will
ensure
that
the
camber
tube
remains
at
90°
to
each
side
frame.
6. Slide
the
camber
tube
forward
or
backward
to
adjust
the
wheelbase
length
to
the
desired
position.
Securely
tighten
the
four
socket
screws.
7. Install
the
rear
wheels.
Refer
to
Removing/Installing
Rear
Wheels
on
page 45.
FIGURE 9.9
Reversing the Camber Tube Clamp Direction
Adjusting Wheelbase Width
NOTE:
For
this
procedure,
refer
to
FIGURE 9.10.
NOTE:
Perform
this
procedure
on
one
side
of
the
wheelchair
at
a
time
for
ease
of
adjustment.
NOTE:
The
wheelbase
width
can
be
increased/decreased
by
1
‐
inch.
1. Remove
the
rear
wheels.
Refer
to
Removing/Installing
Rear
Wheels
on
page 45.
2. Loosen
the
axle
nut
and
rotate
axle
busing
to
increase/decrease
the
wheelbase
width.
3. Securely
tighten
axle
nut.
4. Count
the
number
of
threads
showing
on
the
axle
bushing.
NOTE:
The
number
of
threads
showing
on
the
axle
bushing
should
be
equal
on
both
sides
of
the
wheelchair.
Otherwise,
wheelchair
performance
may
be
affected.
5. Repeat
STEPS
2
‐
3
for
the
opposite
axle
bushing.
6. Install
the
rear
wheels.
Refer
to
Removing/Installing
Rear
Wheels
on
page 45
FIGURE 9.10
Adjusting Wheelbase Width
Washers
Camber Tube
Support
Camber Tube
Clamps
Facing Front of Wheelchair
Facing Rear of Wheelchair
Camber Tube Direction
Camber Tube
Camber Tube
Clamp
Camber
Tube
Camber
Tube
Socket
Screws
Camber
Tube
Axle
Bushing
Threads
Axle Nut
