SECTION 4—FOOTREST
Part No 1134343
23
Crossfire
™
T6A Wheelchair
SECTION 4—FOOTREST
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
ALWAYS perform this procedure in the presence of an assistant. The position of
the footrest, camber tube, seat angle, back angle, the tautness of the back
upholstery as well as the user's condition are directly related to the wheelchairs
stability. Any change to one or any combination of the five may cause the
wheelchair to decrease in stability. Use EXTREME caution when using a new seating
position. The addition of anti-tippers may be required.
Check ALL allen screws that secure the footrest/raised footrest system to the
wheelchair frame to make sure they are securely tightened BEFORE using the
wheelchair. ESPECIALLY if engaging in ANY contact sport.
The footrest assembly MUST be at least 1¾-inches above the ground/floor to avoid
hitting protruding objects when using this wheelchair.
Adjusting/Replacing Standard Footrest
NOTE:
For
this
procedure,
refer
to
FIGURE 4.1.
1. Loosen
the
allen
screw
of
the
two
clamps
that
secure
the
footrest
to
the
wheelchair
frame.
Replacing the Footrest
1. Remove
existing
footrest.
2. Install
new
footrest.
FIGURE 4.1
Adjusting/Replacing Standard
Footrest
WARNING
The standard footrest has an open hoop. A footplate cover is recommended for
wheelchair users that have leg spasticity or whose feet have a possibility of falling
through the footrest hoop. A calf strap is provided with each wheelchair to prevent
the feet from slipping backwards off of the footrest. Be sure the calf strap is secure
when using the wheelchair.
Adjusting the Footrest
1. Position
new/existing
footrest
to
desired
height.
2. Tighten
the
allen
screw
of
the
two
clamps
that
secure
the
footrest
to
the
wheelchair
frame.
Footrest
Clamps (Allen Screws)
Wheelchair
Frame
