Invacare TOP END Crossfire T6A, Руководство владельца по эксплуатации и техническому обслуживанию

Страница: 52 / 68

SECTION 9—WHEELS
Crossfire
™
T6A Wheelchair
52
Part No 1134343
4. Align the desired mounting positions of the camber tube clamps with the opening of
the camber tube supports.
CAUTION
Ensure one empty mounting position remains between the two socket screws, oth-
erwise damage to the wheelchair may occur.
5. Install the four socket screws and washers into the desired mounting positions of both
camber tube clamps. Hand tighten.
NOTE: Ensure that both camber tube clamps are adjust to the same position in the camber tube
support. This will ensure that the camber tube remains at 90° to each side frame.
6. Slide the camber tube forward or backward to adjust the wheelbase length to the
desired position. Securely tighten the four socket screws.
7. Install the rear wheels. Refer to Removing/Installing Rear Wheels on page 45.
FIGURE 9.8 Repositioning the Camber Tube Clamp Socket Screws
Reversing the Camber Tube Clamp Direction
NOTE: For this procedure, refer to FIGURE 9.9 on page 53.
1. Remove the rear wheels. Refer to Removing/Installing Rear Wheels on page 45.
2. Remove the four socket screws and washers that secure the two camber tube clamps
to the camber tube supports.
3. Rotate the camber tube so that the camber tube clamps face the opposite direction.
4. Align the desired mounting positions of the camber tube clamps with the opening of
the camber tube supports.
CAUTION
Ensure one empty mounting position remains between the two socket screws, oth-
erwise damage to the wheelchair may occur.
Socket Screws
Washers
Camber Tube
Support
Camber Tube
Camber Tube Clamp