Invacare Formula CG Elevate, Руководство пользователя

Страница: 57 / 95

Setup/Maintenance
4. Tighten the mounting screw, washer, and locknut that secure
the footplate hinge to the footrest support until the footplate
hinge remains in the up position.
5. Check the up and down motion of the footplate hinge to make
sure the user of the wheelchair can operate the footplates easily.
If footplate's motion is too tight, loosen the
mounting screw and locknut approximately ¼-turn
counterclockwise.
If the footplate's motion is too loose, tighten mounting
screw and locknut approximately ¼-turn clockwise.
6. Adjust footplate. Refer to Adjusting Adjustable Angle Flip-Up
Footplates.
7.12 Installing Adjustable Angle Flip-up
Footplates
The footplate is pre-assembled and is loosely held together
with mounting screws, washers, and locknuts.
The footplate assembly is shown exploded for clarity.
1. Slide the half clamp
A
over the footplate hinge
B
.
2. Hand tighten the two flat screws
C
and locknuts
D
that secure
the footplate
E
to the half clamp.
3. Adjust the footplates to the necessary angle and depth for the
user. Refer to Adjusting Adjustable Angle Flip-Up Footplates.
7.13 Removing/Installing Heel Loop on
Composite Footplate
1. Remove the mounting screw
A
and coved washer
B
that
secures the lower half of the footrest to the swingaway footrest
assembly
C
.
2. Remove the lower footrest assembly.
3. Remove the mounting screw
D
, spacer
E
, and locknut
F
that
secure the heel loop G to the footplate H .
1143155-R-01 57