8 REAR WHEELS
Part No. 1088191
41
Invacare
®
Concept 45 Wheelchair
8 Rear Wheels
8.1
Removing/Installing Rear Wheels
Removing
1.
Remove the dust cap, permanent axle, washer and locknut that secure rear wheel to the axle bracket.
2.
Remove existing rear wheel from the wheelchair.
3.
If necessary, repeat STEPS 1-2 for opposite rear wheel.
Installing
1.
Install permanent axle through the rear wheel, axle bracket, washer and locknut.
2.
Securely tighten with the existing locknut. Torque to 20-40 ft-lbs.
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise
injury or damage may occur.
WARNING
Only a qualified technician may change the size of the rear wheel or the seat-to-floor height.
If changing the size of the rear wheel or a change in the seat-to-floor height is desired, this procedure MUST be performed
by a qualified technician.
Make sure both rear wheels are the same size and are installed into the same respective mounting hole before using the
wheelchair, otherwise injury may occur.
If replacing the same size rear wheel, note the mounting position on the wheelchair frame for proper reinstallation of the
new rear wheel.
