intrepid KM100, Руководство пользователя, Страница: 12 / 54

• The machine is suitable for driving on the public highway, provided it has the
correct registration documents, the correct traffic lighting and permits.
• The workplace must be sufficiently lit at all times.
• It is the responsibility of the operator to ensure that bystanders (people who are not
the operator) cannot get into the path of the machine, the interchangeable
accessories or the loads.
2.2.4 Safety instructions during certain activities
• Make sure that no one is at risk.
• If there is danger, give a warning signal and stop the machine if necessary.
• Before using the machine, allow the machine to warm up in a well-ventilated area.
• If you do not have sufficient visibility, make sure you are assisted by trained
personnel. This personnel must be recognizable and stay within your field of vision at
all times.
• The machine must not be used in landfills where there is a risk of the machine falling,
unless there are provisions that prevent rolling or crashing.
• When you are no longer using the machine, stop the machine.
• Before stopping the machine, remove the interchangeable accessory according to the
instructions in this manual and place the interchangeable accessory in a safe location.
• If the hydraulic steering cylinder fails, fit the jib lock rod. See section 4.10 .
• At all times prevent persons going under the load.
• People must remain at a distance of 5 meters from the working machine.
• Explore the surrounding area and remove any obstacles.
2.2.5 Instructions concerning certain risks
• Make sure you know where the fire extinguishers are.
• In the event of fire: keep a sufficient distance away from the machine. If the hydraulic
fluid lines overheat, they can break and cause flash fires of burning hydraulic fluid.
• Use only fuses from the manufacturer.
• Avoid prolonged overloading of the hydraulics. This causes overheating of the
machine. Always ensure that the hydraulic control is in the neutral position when
starting the machine.
• Check the hydraulic fluid level daily and top up if necessary.
• Replace the hydraulic fluid filters and the hydraulic fluid at least once a year.
• Be careful when using hydraulic fluid and battery acid.
• Avoid high speeds with a low oil temperature: drive for the first 5 minutes at an
increased engine speed (1500 rpm), without a load.
• Refueling:
• Before refueling:
• Switch off all electrical systems.
• Switch off the engine and allow the engine and exhaust to cool down to a hand-
warm temperature.
• Refuel in a well-ventilated area.
• Do not refuel near open flames or sparks.
• Do not smoke while refueling.
• Make sure that no fuel, oil or grease gets on the machine.
• Only use the machine in well-ventilated areas.
• Only use original parts from the manufacturer.
Safety
12 11 - 002 - 30.08.2018