Intralox ThermoDrive, Инструкция по эксплуатации

Страница: 17 / 78

2 SPLICING SYSTEM COMPONENTS
2-4
Belt Splicing System v.2.0
Heat Wand:
Electrically operated, heating
platen used to melt Intralox ThermoDrive belt
ends for splicing; designed to be connected to
the Temperature Control Box and used with the
Clamping Fixture; designed to maintain set-
point temperature for a series of splices covered
with Teflon tape to allow easy removal of
melted plastic residue
NOTE
Use the Heat Wand in temperatures above 40°F
(5°C) to produce quality splices. To use the
Splicing System below 40°F (5°C),
see
TROUBLESHOOT
on page 10-1.
Stand:
Metal guard designed to hold the Heat
Wand upright, allow handle access during use,
and prevent accidental contact with the Wand;
also protects work surfaces that might be
burned by the Wand; Heat Wand should be
returned to Stand after each splice
NOTE
Connect the Heat Wand to the Temperature
Control Box BEFORE connecting the Temperature
Control Box to an electric outlet.
Contact with hot Heat Wand or Stand
will cause skin burns.
Place the Wand Stand on a hard, heat-
resistant surface (NOT a belt) during
use.
Keep Heat Wand in the Stand when not
in use.
Heat Wand and Temperature Control Box
Figure 2E: Heat Wand components
Heat Wand
Stand
Temperature
Control Box
Electric Cord
Power Switch
Heat Wand and
Stand
Wand Cord