(307IO) HEAT PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 12/15/2016
English
307
IO
SAVE THESE INSTRUCTIONS
English
Page 8
SET UP INSTRUCTIONS
• Never install the unit in a closed room with a limited air volume in which the air expelled from
the unit will be reused, or close to garden plants that could block the air inlet. Such locations
impair the continuous supply of fresh air, resulting in reduced efficiency, performance and
possibly preventing sufficient heat output.
• During normal operations, the heat pump evaporator fins produce condensation water. The
amount of condensation produced varies according to ambient conditions. The higher the air
humidity, the higher the amount of condensation produced (several liters per day). The lower
heat pump panel acts as a condensation collection tray. Keep the drain hole clean.
• The heat pump must be positioned to avoid damages caused by water or condensation
leaks. Install suitable drainage outlets or collection containers.
• The heat pump must be fixed and installed on a flat, solid, vibration free and level support
(cement slab or prefabricated platform). Do not install the heat pump on unstable ground.
• To reduce noise wave echoes, do not install the heat pump in the immediate vicinity of vertical
walls and use the included anti-vibration pads during installation.
• Make sure the pump is not subject to rain water flows from nearby building roofs. Protruding
roofs without gutters could pour significant amounts of water and/or debris on the heat pump
which could damage it. If necessary, install gutters or discharge outlets to protect the heat
pump.
• Make sure the heat pump is not within the range of any sprinkler or irrigation systems. If
necessary, install suitable protections.
500mm
300mm
700mm
700mm
2500mm
IMPORTANT
Always keep the unit upright. If the unit has been tilted or put on its side, wait 24 hours
before starting the heat pump.
Location and Space Requirement
• The heat pump must be installed outdoors and more than 2m away from the pool. It can not
be installed indoors.
• Minimum clearance required for the heat pump installation as follow:
