Interroll 24 V belt conveyor straight / curve
BM 8350 / BM 8360
Maintenance and repair
Version 1.1 (02/2016) en-US
Translation of original instruction manual
49
4
Pull off old conveyor belt (3) on the open non-cable side from the drive roller (5) and
tensioning roller (2) and dispose of it properly.
4
Pull new conveyor belt from the non-cable side onto the drive roller (5) and carrying roller
(2).
4
NOTICE! Ensure that the belt-guiding taper strip lies in the grooves of the rollers.
4
Re-insert eyebolts of the tensioning roller (2) and the adjacent carrying idler on the non-cable
side and tighten on both sides,
See "Replacing the tensioning roller in the straight section",
page 42
.
4
Re-install the tensioning device on the non-cable side.
4
For the drive roller: Re-insert the closing clip on the non-cable side and tighten the ribbed nut
on the cable side,
See "Replacing the drive roller in the straight section", page 44
.
4
Re-insert the carrying idlers,
See "Replacing the carrying idler in the straight section",
page 40
.
4
Adjust the belt tension,
See "Adjusting belt tension in straight section", page 38
.
4
Attach the side cover.