Interroll 24 V belt conveyor straight / curve
BM 8350 / BM 8360
Maintenance and repair
40
Version 1.1 (02/2016) en-US
Translation of original instruction manual
Replacing the carrying idler
Replacing the carrying
idler in the straight section
2
1
3
3
1
Belt
3
Closing clip
2
Carrying idler
Requirement:
R
The module is out of operation.
4
Loosen the belt tension,
See "Adjusting belt tension in straight section", page 38
.
4
Remove closing clips (3) on both sides of the roller with needle-nose pliers,
See "Replacing the
roller clip", page 52
.
4
Push up the belt (1) and remove carrying idler (2) between belt and side frame.
4
Insert new carrying idler underneath the belt and place it in the open elongated hole.
The pocket holes for carrier rollers and RollerDrive are closed with clips after the installation:
4
Close the pocket holes over the carrier rollers using roller clips.
4
Close the pocket holes over the RollerDrive with a suitable clip.
4
Optional: Close empty pocket holes with a dummy clip.
4
Insert the closing clip until it completely snaps into place.
4
Adjust belt tension at tensioning roller using the tensioning device,
See "Adjusting belt tension
in straight section", page 38
.