Intermec EasyCoder PD42, Руководство пользователя

Страница: 53 / 126

Chapter 4 — Troubleshooting and Maintaining the Printer
EasyCoder PD42 Printer User’s Guide 43
Other Printing Operation Problems
Problem Solution / Reason
The Power control LED is
not lit when power is
switched on. Check that the power cable is correctly
connected to the printer and electrical
outlet.
Error LED is turned on
after printing. • Check if printer is out of media or
ribbon.
• Check if media is jammed or tangled.
• Check that the print mechanism is
locked and closed correctly.
• Check the cutter.
• Check application.
Label is jammed after
printing. Clear the media jam (see “Clearing Media
Jams” on page 49 ). If the label is stuck on
the thermal printhead, clean the printhead
(see
“Cleaning the Printhead” on
page 57 ).
When printing, labels are
skipped. • Run a new testfeed (press ( )).
• Check if label gap sensor is disturbed
by dust or foreign particles (see
“Adjusting the Label Gap Sensor” on
page 53
).
When using cutter, label is
not cut straight. • Check whether the media thickness
exceeds 0.25mm (9.8 mils).
• Check that the media is loaded
correctly. Check that the media runs as
close to the center section of the printer
as possible, and that the paper path is
straight.
When using cutter, label
cannot feed or abnormal
cutting occurs. • Check that the cutter is installed
properly.
• Check if paper feed rods are sticky.
Clean if needed (see “Cleaning the
Media Compartment” on page 58 ).
When using internal
rewinder, abnormal
function occurs. Check that media is loaded correctly.
Printer keeps printing or
feeding when it should
stop. • Check media settings.
• Check label gap sensor position.
• Clean if sensors need cleaning.
Printing is slow. Check application.
Test