Intermec EasyCoder PD42, Руководство пользователя

Страница: 122 / 126

Appendix D — Setup Parameters (IPL)
112 EasyCoder PD42 Printer User’s Guide
Darkness
Use this parameter to make minor adjustments of the blackness
in the printout, for example to adapt the printer to variations in
quality between different batches of the same media type. The
value can be set within the range -10% to +10% where -10 is the
lightest and 10 is the darkest. Default value is 0%.
Label Rest Point
Specifies where labels stop for removal. Use this for peel-off (self-
strip) applications. Allowed range is -30 (furthest back) to 30
(furthest forward). Default is 0. Also available as an IPL
command (
<SI>fn
).
Form Adj Dots X
Specifies where the X-position of the origin should be placed on
the label. Allowed range is -30 (closest to the leading edge) to 30
(furthest from the leading edge). Default is 0.
Form Adj Dots Y
Specifies where the Y-position of the origin should be placed on
the label. Allowed range is -30 (closest to the center section) to 30
(furthest from the center section). Default is 0.
Configuration Setup
Power-Up Emulation
Emulation mode lets you print bar code labels that were
originally designed on an 86XX printer in multiples of 10 or 15
mil. When the printer is working in emulation mode, not all IPL
commands are supported. For a complete list of commands
available during emulation mode, see the the
IPL Programmer’s
Reference Manual (P/N 066396-xxx).
Default emulation mode is “none”.
Print Speed
You can select the print speed from 2 in./sec. (50 mm/sec.) to 6
in./sec.(100 mm/sec.) with an interval of 1 in./sec. The higher
the print speed, the more wear on the printhead, so do not use a
higher print speed than necessary. For some direct thermal media
or ribbon/media combinations, setting the highest print speed
may reduce print quality significantly.