Intermec CV60, Руководство пользователя

Страница: 90 / 110

Windows Device Configurations Chapter
—
4
78 CV60 Vehicle-Mount Computer User's Manual
How to configure tethered scanners 1551E/1553/1800/1400
Tethered scanners can be configured from the Intermec Settings" on the
CV60. Follow these steps:
1 Connect a tethered scanner to the tethered scanner port.
2 Under the tethered scanner folder, select the scanner model to match the
attached scanner type. If the scanner port state is not already enabled,
then enable it.
Note: during this process the terminal is trying to communicate to the atĆ
tached scanner.
You will see a Failed to save one or more settings" message if:
S the scanner is not powered
S the cable is not properly connected
S if the wrong cable is used
S if the scanner firmware is older than version 2.0.
Note: that this process can take up to 8 seconds since the terminal is going
through a group of RS323 settings to trying to communicate with the
scanner.
The auto-baud process is performed whenever the scanner port state is
changed from Disable to Enable or whenever the 1551E/1553 is selected
from the scanner model list and the scanner port state is enabled.
If the auto-baud process is successful, about eight beeps will be generated,
and it is followed by another series of beeps depending on the firmware
version installed in the scanner. The latter series of beeps are suppressed
since FW 2.08.