Intermec 6820 Series, Руководство пользователя

Страница: 94 / 184

Control Code Definitions Chapter
—
5
78 6820 Series 80-Column Printer User’s Manual
Perform Horizontal Tab
The print position is moved to the next horizontal tab stop. The tab posi-
tions, set by ESC “D”, the
Set Horizontal Tabs function, are not affected
by any changes in character pitch.
The factory default tab settings are at intervals of eight characters, in the
currently selected pitch. For the default tabs, the actual distance to each
tab position is affected by changes in character pitch.
Format
Decimal Hex ASCII
9 09 HT
Set Horizontal Tabs
The current horizontal tabs are reset, and new horizontal tabs are set up,
based on the current character width (pitch).
Format
Decimal Hex ASCII
27 68 n1 n2 ... nk 0 1B 44 n1 n2 ... nk 00 ESC “D” n1 n2 ... nk NUL
where, n1 is the first tab (range for tab stops: 1–255), n2 is the second
tab (all tabs in ascending order) , ... are subsequent tabs (maximum tabs:
32), nk is the last tab to set (any value less than the previous tab value
acts as a terminating character), NUL is the terminating character.
Clear Horizontal Tabs
All horizontal tab stops are cleared. It is merely a variant behavior of the
Set Horizontal Tabs function, where the NUL acts as an early terminating
character, as existing tabs normally clear before setting any new tabs.
Format
Decimal Hex ASCII
27 68 0 1B 44 00 ESC “D” NUL
Vertical Tabs
Vertical tabs: set tabs, tab to next tab stop, clear tabs, set tab increments,
set tabs in channels, select a tab channel
S Tab positions are line numbers, counting from the Top of Form.
S All tabs set beyond the page length are stored, but are not used.
S
Any tab set within the SOP range (Skip Over Perforation), during the
time SOP is active, are stored but not used until SOP is canceled.
S
If a vertical tab, and the next tab stop is outside the printable page area,
a form feed is executed placing the print head at the next Top of Form.
S All previous tab stops are cleared when new tab stops are set.
S
Tab settings are not affected by subsequent changes in line spacing.