Interlogix UltraView PTZ, Руководство по установке

Страница: 34 / 68

UltraViews PTZ
Installation Manual 24
Wiring the housing board
To wire the housing board, do the following:
1. Connect the facility data cables to the main connections, which are the B and A terminals on the
provided 6-pin or 2-pin terminal strip ( Figure 20 ). The main data connections on the terminal strip are
for control wires that are coming in from the keypad. You may also daisy-chain the data signal to
additional domes.
Note: If you are installing RS-485 data, float the shield at the dome and connect it at the keypad.
Figure 20.Data connections
2. Connect the facility video cable ( Figure 21 ).
Note: Use only crimp-on BNC connectors. Do not use screw-on connectors.
Figure 21.Video connection
If you are installing UTP video, use the UTP terminals on the six-pin terminal strip ( Figure 20 ). It provides
connections for UTP video. If you are installing coaxial video, locate the BNC connector ( Figure 17 ).
Note: UTP, which is polarity sensitive, is only available on UPIB modules with a six-pin connector.
WARNING: Do not run any cables next to the heaters. Doing so could damage the dome or cause an electrical fire.
B A B A
UTP-
UTP+
Primary A
RS-422/485 + Auxiliary B
RS-485 –
Primary B
RS-422/485 – Auxiliary A
RS-485 +
Daisy chain
Video UTP
+ and -
Coaxial video BNC