Interlogix UltraView PTZ, Руководство по установке

Страница: 33 / 68

Chapter 3
Wiring
23
Alarm/contact connectors
Figure 18 shows the descriptions for the alarm/contact terminals at the bottom edge of the housing board. The
inside of the camera housing has a color-coded label to help you determine which terminal is which. These
connectors are only available on advanced housing models.
Note: The RS-485 AUX is use d for position reporting t o an outside source. When the settings are 9600 baud and
ASCII, the position is reported as P: XXX.X; T: XXX .X; Z: XXX.X.
Figure 18.Data and alarm/contact connectors (UPIB housing only)
Note: Use dry contacts for alarms. This unit’s relays are rated to a maximum operating voltage of 30 VAC or 30 VDC at
0.5 A.
Figure 19.Data and alarm/contact connectors (Low-end DPIB only)
Table 5. UltraViews PTZ housing interface board UTC LED functions
Configuration type LED Description
UPIB housing Power LED Indicates power is applied to the housing.
Green Indicates communication activity:
• Blinks at a fast rate (7 Hz) when FSK (frequency shift keying) decoder
is tuning.
• Blinks at a slow rate (0.5 Hz) when decoder is locked and receiving
(UTC only).
DPIB housing Power LED Indicates power is applied to the housing card.
Green Indicates communication activity:
• Blinks irregularly—at various rates—during communication between
the PTZ and the housing interface board.
C
ALM1 ALM3
C
ALM2
C
ALM4
C
COM1
NO1 NC1
COM2
NO2 NC2
A
AUX
B 422/485
A
422/ 485
UTP
‒
UTP
+
B AUX
Primar Alarm inputs Relay 1 Relay 2 Aux Video
B 485
A
485