Interlogix TVP-6101, Руководство по установке

Страница: 43 / 60

Installation Guide 39
To mount the wall mount:
1. Remove the rubber plugs on the two sides of the PTZ
housing.
2. Unscrew the two screws located below the rubber plugs.
3.
Open the bubble assembly and remove the foam insert
and the plastic protective lens cover.
4. Set the address and baud rate for the dome as shown on
the page 17.
5. Attach the safety lanyard to the wall mount.
6. Use the supplied template to mark out the mounting area.
Drill four screw holes in the wall according to the holes of
the wall mount, and then insert M 8 expansion screws (not
supplied) into the mounting holes.
7. Attach the wall mount to the wall by aligning the four
screw holes of the wall mount with expansion anchors on
the wall.
8. Secure the wall mount with screws enclosed with the
mount.