Interlogix TruVision TVP-5104, Руководство по настройке

Страница: 54 / 82

52 TruVision IP PTZ Camera Configuration Manual
3. Click Draw Area , and then draw a rectangle on the image as the designated region.
When you draw the rectangle, all lines should connect end-to-end to each other. Up
to four areas are supported. Click
Clear to clear the areas you have drawn. The
designated region parameters can be set up separately.
Note: The area can only be quadrilateral.
4. Select the region to be configured.
Sensitivity: The sensitivity value defines the size of the object that can trigger the
alarm. When the sensitivity is high, a small object can trigger the alarm. The range
is between 1 and 100.
Detection Target: You can select human, vehicle, or all (human &vehicle) as the
detection target from the dropdown list. If Human is selected, only human beings will
be identified as detection objects and as well as Vehicle.6. Choose the Detection
Target from All, Human or Vehicle.
5. Set the arming schedule for the region existing detection. The arming schedule
configuration is the same as that for motion detection. See “Motion detection
alarms” on page 39 for more information.
6. Select the actions to be used for the region existing detection. The options are:
Notify Surveillance Center Send an exception or alarm signal to remote management
software when an event occurs.
Send Email Sends an email to a specified address when there is a motion
detection alarm.
Upload to FTP/Memory
Card/NAS Capture the image when an alarm is triggered and upload the
picture to NAS or FTP server.
Intelligent Tracking Triggers the intelligent tracking function
Trigger Recording Triggers the recording to start in the camera.
Trigger Alarm Output Trigger external alarm outputs when an event occurs. Select
one of the options: Select Trigger Alarm Output, A->1, or A-
>2.
Note: This option is only supported by cameras that support
alarm output.
7. Click Save to save changes.
Unattended baggage detection
Unattended baggage detection function detects the objects left in the designated region
such as baggage, a purse, dangerous materials, etc. A series of actions can be
configured to occur when the alarm is triggered.
To set up unattended baggage detection:
1. From the menu toolbar, click Camera Configuration > Alarm/Event Setup>
Unattended Baggage Detection .